首页- 新闻中心- 正文

AT90USB1287芯片解密

来源:芯片解密-龙芯世纪   时间:2010-05-19   阅读:976

AT90USB1287芯片解密等ATMEL系列单片机解密需求者欢迎与龙芯世纪科技联系,依靠在ATMEL系列芯片解密技术研究中的丰富解密经验及项目研究成果,我们能够针对华邦系列大部分典型单片机提供优质可靠的解密方案。
  
  下面是关于AT90USB1287芯片的主要技术特征介绍,供大家做技术参考和分析。如果客户有AT90USB1287芯片解密等ATMEL系列单片机解密需求,欢迎与龙芯世纪科技联系咨询更多解密详情

High Performance, Low Power AVR? 8-Bit Microcontroller
  Advanced RISC Architecture
  – 135 Powerful Instructions – Most Single Clock Cycle Execution
  – 32 x 8 General Purpose Working Registers
  – Fully Static Operation
  – Up to 16 MIPS Throughput at 16 MHz
  – On-Chip 2-cycle Multiplier
  Non-volatile Program and Data Memories
  – 32/64/128K Bytes of In-System Self-Programmable Flash
  Endurance: 100,000 Write/Erase Cycles
  – Optional Boot Code Section with Independent Lock Bits
  USB Bootloader programmed by default in the Factory
  In-System Programming by On-chip Boot Program hardware activated after
  reset
  True Read-While-Write Operation
  All supplied parts are preprogramed with a default USB bootloader
  – 1K/2K/4K (32K/64K/128K Flash version) Bytes EEPROM
  Endurance: 100,000 Write/Erase Cycles
  – 2.5K/4K/8K (32K/64K/128K Flash version) Bytes Internal SRAM
  – Up to 64K Bytes Optional External Memory Space
  – Programming Lock for Software Security
  JTAG (IEEE std. 1149.1 compliant) Interface
  – Boundary-scan Capabilities According to the JTAG Standard
  – Extensive On-chip Debug Support
  – Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
  USB 2.0 Full-speed/Low-speed Device and On-The-Go Module
  – Complies fully with:
  – Universal Serial Bus Specification REV 2.0
  – On-The-Go Supplement to the USB 2.0 Specification Rev 1.0
  – Supports data transfer rates up to 12 Mbit/s and 1.5 Mbit/s
  USB Full-speed/Low Speed Device Module with Interrupt on Transfer Completion
  – Endpoint 0 for Control Transfers : up to 64-bytes
  – 6 Programmable Endpoints with IN or Out Directions and with Bulk, Interrupt or
  Isochronous Transfers
  – Configurable Endpoints size up to 256 bytes in double bank mode
  – Fully independant 832 bytes USB DPRAM for endpoint memory allocation
  – Suspend/Resume Interrupts
  – Power-on Reset and USB Bus Reset
  – 48 MHz PLL for Full-speed Bus Operation
  – USB Bus Disconnection on Microcontroller Request
  USB OTG Reduced Host :
  – Supports Host Negotiation Protocol (HNP) and Session Request Protocol (SRP)
  for OTG dual-role devices
  – Provide Status and control signals for software implementation of HNP and SRP
  – Provides programmable times required for HNP and SRP
  Peripheral Features
  – Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode
  – Two16-bit Timer/Counter with Separate Prescaler, Compare- and Capture Mode– Real Time Counter with Separate Oscillator
  – Four 8-bit PWM Channels
  – Six PWM Channels with Programmable Resolution from 2 to 16 Bits
  – Output Compare Modulator
  – 8-channels, 10-bit ADC
  – Programmable Serial USART
  – Master/Slave SPI Serial Interface
  – Byte Oriented 2-wire Serial Interface
  – Programmable Watchdog Timer with Separate On-chip Oscillator
  – On-chip Analog Comparator
  – Interrupt and Wake-up on Pin Change
  Special Microcontroller Features
  – Power-on Reset and Programmable Brown-out Detection
  – Internal Calibrated Oscillator
  – External and Internal Interrupt Sources
  – Six Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, Standby, and Extended Standby
  I/O and Packages
  – 48 Programmable I/O Lines
  – 64-lead TQFP and 64-lead QFN
  Operating Voltages
  – 2.7 - 5.5V
  Operating temperature
  – Industrial (-40°C to +85°C)
  Maximum Frequency
  – 8 MHz at 2.7V - Industrial range
  – 16 MHz at 4.5V - Industrial range
龙芯世纪科技专业承接AT90USB1287解密、AVR解密、ATMEL单片机解密、IC解密、DSP解密、PLD解密、FPGA解密等IC解密项目合作。

更多芯片解密资料请参考 http://www.icinf.com